Type - displays whether the library is an Integrated library or a Vault library.

Path - displays the file name of the library.

Only activated libraries are accessible from the Libraries panel.

Activated - select or deselect to designate whether a library is activated or not.

Installed Libraries - displays the file names of installed libraries used in the active project, including the file extension.

The Installed tab, including both Install options.

You can also install new libraries, remove libraries, and activate or deactivate libraries. This tab lists out all libraries that are currently available for this installation of Altium Designer.

Remove - click this button to remove the highlighted project library from this list.

Add Library - click to open your file browser and select a library file from your local drive, which you wish to add to the list of project libraries.The ordering of the list is important when the list is used for the model-link verification when, for example, compiling the project, synchronizing, or running a simulation. Move Down - click to move the highlighted project library down in the list.Move Up- click to move the highlighted project library up in the list.For example, a PCB library or Schematic library. Type - displays the type of library document listed.Path - allows you to see where the library is saved by displaying the file path.Project Libraries - displays the file names of library documents used in the active project, including the file extension.You can also use this tab to add libraries to the project or change the order of the project libraries.īoth Schematic Libraries and PCB libraries are listed in the Project tab of the dialog. The Project tab lists all libraries that have been added to current project.

Right-click on a component in the Component List of the Libraries panel then select Add or Remove Libraries.Click the Libraries button in the upper left corner of the Libraries panel.

The Available Libraries dialog can be accessed from the Libraries panel in either of the following ways: Components and models can only be placed into an open design from libraries defined in one of the tabs in this dialog.

Opal kelly int library altium designer